Msn Assignment For The Sensor; Number Dialed By Sensor Activation - Siemens HiPath 1100 Programming Manual

Step by Step
...
0
0 1
...
0 0 1

MSN Assignment for the Sensor

This setting specifies an MSN for the system. This MSN
will be used for outgoing calls. By using this MSN the
called party is able to identify the origin of the call. For
instance, this would be the case for an alarm.
The default configuration does not specify a MSN.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
0 5 1
Enter the slot for the MSN number.
1 4 0
Initial state for Programming Mode.
Deleting
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
0 5 1
1 4 0 Enter the slot for the MSN number.
Press the key to remove it.
*
Initial state for Programming Mode.

Number Dialed by Sensor Activation

This setting specifies the number to be automatically
called when a specific sensor is activated. The number
to be dialed when the sensor is activated is stored in
the System Speed Dialing phonebook in entry 249.
When the number stored in the System Speed Dialing
is changed, this field is updated. Similarly, when the
number in the field is changed, the change is reflected
in the System Speed Dialing phonebook.
The default configuration does not specify any number.
Required: Programming Mode must be active (*95
31994).
0 5 2 Enter the code for programming.
Enter the number to be called (up to 20 digits).
Initial state for Programming Mode.
Relay and Sensor on the HiPath 1120
167