Module Detection - Siemens HiPath 1100 Programming Manual

Step by Step
0 0

Module Detection

This setting resets the ports for the selected slots.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
0 6 1
...
Enter the slots for the new modules:
2 0
0 0
0 1
# Press this key.
Initial state for Programming Mode.
When the "00" option is selected, the system detects
the components as described on
This means that if a numbering sequence for analog
lines/extensions has been previously configured it will
be changed when a S
added.
Example 1: In a HiPath 1150 system that has only a MB
Module (2 external lines and 10 analog extensions) the
numbering pattern will be 801 and 802 for external ana-
log lines, and from 11 to 20 for analog extensions. When
a S is added you have:
0
- 803 to 806 for the digital lines
- 21 to 25 for S
Example 2: for a HiPath 1190 system:
MB + EB 210 + S
801 to 802 - External analog lines
101 to 110 - Analog extensions
803 to 812 - S
111 to 115 - S
If a specific slot is selected (01 to 20), the previous num-
bering will be maintained and the system will only de-
tect the module.
= Detects all slots (defaults)
to = Detects only the specified slot
2 0
Module or a TME1 Module is
0
extensions
0
- 5 ports
0
digital lines
0
extensions
0
The modules can only be connected/disconnect-
ed when the system is turned off.
General Programming
page 18.
111