Warmline - Siemens HiPath 1100 Programming Manual

Step by Step
Deactivation of Hotline mode
Required: Programming Mode must be active (*95
31994).
1 4 5 Enter the code for programming.
Enter the extension number (e.g. 12/102) for which you
want to remove a Hotline assignment.
The Hotline Mode is deactivated.
*
Enter the next extension number.
or
# Press this key.
Initial state for Programming Mode.

Warmline

Specify the length of time the extension should wait to
call the first number configured as a Hotline. Assuming
the timeout is 9 seconds, the call will be made 9 sec-
onds after the handset is lifted. However, if during the 9
second time interval a key is pressed on the phone key-
pad, the call to the Hotline will be canceled.
Each extension can have a different timeout for activat-
ing a Hotline. This timeout may vary from 0 to 9 sec-
onds.
By default, the Hotline activation timeout is "0 seconds".
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
1 6 2
Enter the extension number (except 11/101, for exam-
ple, 12/102) for which you want to change the timeout.
...
Enter the length of time (0 to 9 seconds) for the Hotline
0 9
timeout.
Enter the next extension number.
or
Press this key.
#
Initial state for Programming Mode.
Programming an Extension
77