Activating/Deactivating The Timer For Outgoing External Calls; Timeout For A Second Attendant For Msn - Siemens HiPath 1100 Programming Manual

Step by Step
*
...
0 0 1
0 1
Enter the length of time for the duration of external calls
for the specified extension (00000 to 17280 in 5-second
increments), where 00 = 0 seconds ... 36 = 180 sec-
onds (default), etc.
Enter the next extension number.
or
Press this key.
#
Initial state for Programming Mode.
Activating/Deactivating the timer for outgo-
ing external calls
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
0 4 8
Enter the extension number (e.g. 11/101).
or
Activate/Deactivate the timer for an outgoing external
#
call:
* = To activate
= To deactivate (default)
#
Initial state for Programming Mode.
Timeout for a Second Attendant for
MSN
This consists of a time period (in seconds) during which
an incoming call rings at the First Attendant of an exter-
nal line. If the call is not answered within the specified
amount of time, it will be routed to a Second Attendant
(see "Modem Extension" on
The default configuration is set to 30 seconds.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
0 8 2
Enter the slot (001... 140) for the MSN.
1 4 0
...
Enter the delay time (01 to 20 in 5-second increments)
2 0
where 00 = 0 seconds... 06 = 30 seconds (default), etc.
Initial state for Programming Mode.
Programming an Extension
page 86).
85