Tme1 Module; U P0/E Module - Siemens HiPath 1100 Programming Manual

TME1 Module

TME1 Module can only be installed in Slot 3 (
Warning: Do not touch the administration serial interface connector
of the TME1 module before disconnecting all analog extensions and
trunk connectors. Failure to follow this procedure may expose the
user to dangerous voltages. The TME1 module interconnecting ca-
bles and connectors should only be handled by qualified technical
personnel.
U Module
P0/E
For the HiPath 1150 the U
In order to use a U
P0/E
MB ( page 206).
module can only be installed in Slot 1 or 2.
P0/E
module you must install a CTR-U
Setup and Installation
page 206).
module on the
P0/E
213