Relay And Sensor On The Hipath 1120; Sensor; Programming The Sensor's Function - Siemens HiPath 1100 Programming Manual

Step by Step
1
Relay and Sensor on the
HiPath 1120
You can connect a Music module to the HiPath 1120 sys-
tem. This module also provides a Relay and a Sensor for
integrating other devices such as an Entrance Telephone,
a Door Opener, alarms, etc.

Sensor

When the state of the sensor contact changes, for ex-
ample, when an open contact closes, the following
functions can be executed:
• Selecting a number in the Speed Dialing Directory
• Activation of a relay
• Dialing a number from the Speed Dialing directory
and activating a relay
• Sending a Message (with the EVM Module)
The activation logic based on the initial position of the
sensor contacts and its resulting actions are program-
mable.

Programming the Sensor's Function

Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
7 0
...
Select the sensor's function:
0 3
0 = Deactivate the sensor's function (default)
= Dial the number specified in "Number Dialed by
1
Sensor Activation" (Code 052).
= Activate the relay through the sensor
2
= Detect DTMF code. When this setting is selected,
3
the number that was called must acknowledge or
ignore an alarm call by sending an acknowledge-
ment code ("#" DTMF signal )
Press this key.
#
Initial state for Programming Mode.

Relay and Sensor on the HiPath 1120

165