Sensor Message; Relay - Siemens HiPath 1100 Programming Manual

Step by Step
1

Sensor Message

After assigning a number, you can assign a message to
the sensor. This message will be transmitted to the as-
signed number when the sensor state is changed.
Required: Programming Mode is activated (*95 31994)
and an EVM Module is installed.
2 1 3 Enter the code for programming.
or Select a Message:
1 2
= Message 1
1
2 = Message 2
Initial state for Programming Mode.

Relay

The relay can be activated via the sensor, assuming that
the sensor is configured. It can be activated manually or
automatically after a specified time. When the relay is
activated, the contacts close. When it is deactivated,
the contacts open.
By default, the relay is set to Switch Mode.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
7 5
...
1 5 Select the operating mode for the relay:
1 = "Switch": The relay can only be turned on from an
2 = "Monoflop": The relay is closed for a specified
= "Switch": The current state of the really is reversed
3
Relay and Sensor on the HiPath 1120
extension by entering the proper feature code
(see Miscellaneous Functions - Relay in the User
Manual).
length of time. Alternatively, the relay can also be
opened before the set time, by entering the prop-
er feature code (see Miscellaneous Functions -
Relay in the User Manual).
when the feature code for activating the Relay is
selected at an extension.
169