Uploading The Sw Update; Setting A System Password - Siemens HiPath 1100 Programming Manual

Step by Step
h h

Uploading the SW update

This setting specifies when the data downloaded will
be uploaded to the system's memory.
When this upload is in progress (during approximately 3
minutes) the telephone operates as usual.
The default setting specifies for data to be transferred
at 00:00 hours.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
0 5 9
: m m Enter the hour (00 to 23) and the minutes (00 to 59) for
starting the uploads.
Initial state for Programming Mode.

Setting a System Password

The system's Programming Mode is protected by pass-
word against unauthorized use. The default password is
"31994." This password can be changed.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
1 8 0
Enter a new system password (5 digits).
Confirm the new password by entering it again (5 dig-
its).
Initial state for Programming Mode.
For future reference it is recommended that you
write down your password and store it in a safe
place. If you forget your password, consult a sup-
port technician to obtain access to program-
ming.
General Programming
107