Assigning A Class Of Service (Cos) - Siemens HiPath 1100 Programming Manual

Main Configurations
Step by Step
34

Assigning a Class Of Service (COS)

Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
1 1 1
Enter the number for the group of external lines (e.g., 0,
890...899).
Enter COS for Day and Night Service.
D N
:
D
:
N
Instead of entering
= No Trunk Access (No Permission)
0
1 = Outward-Restricted Trunk Access with Denied
= Outward-Restricted Trunk Access with Denied
2
= Outward-Restricted Trunk Access with Denied
3
4 = Outward-Restricted Trunk Access with Permis-
= Outward-Restricted Trunk Access with Permis-
5
= Outward-Restricted Trunk Access with Permis-
6
= Unrestricted Trunk Access (default for all lines)
7
...
Enter the extensions (e.g., 11/101) to which the COS se-
lected will be assigned.
# Press this key.
Initial state for Programming Mode.
To assign a COS to additional lines, repeat the program-
ming steps described above. The default for all exten-
sions is "77 ."
Enter COS for Day Service
Enter COS for Night Service
or
D
List 1
(4 slots)
List 2
(10 slots)
List 3
(35 slots)
sion List 1
(4 slots)
sion List 2
(10 slots)
sion List 3
(25 slots)
enter the following COS:
N