Cos Changeover; Attendant Console (Ac) - Siemens HiPath 1100 Programming Manual

Main Configurations
Step by Step
36

COS Changeover

You can allow or deny a temporary COS Changeover
from an extension to a different extension.
Required: Programming Mode must be active (*95
31994).
1 7 8 Enter the code for programming.
Enter the extension number (e.g., 11/101).
or
To allow/deny COS Changeover:
* #
* = To allow
= To deny (default)
#
Enter the next extension number
or
Press this key.
#
Initial state for Programming Mode.

Attendant Console (AC)

The Attendant Console centralizes the flow of calls at
up to two answering stations equipped with system
telephones with a display. In the default configuration
no Attendant Console is configured.
Required: Programming Mode must be active (*95
31994).
1 5 0 Enter the code for programming.
Enter an extension number for the Attendant Console
(e.g., 12/102).
Enter the next extension number, if you like.
or
Press this key.
#
Initial state for Programming Mode.