Call Detail Report Filter; Call Detail Report Through Serial; Interface - Siemens HiPath 1100 Programming Manual

Step by Step
Wait 5 seconds
*
= Outgoing calls are recorded at the end of the call.
4
Initial state for Programming Mode.

Call Detail Report Filter

The number programmed in this filter specifies the type
of outgoing call to be recorded, based on the first four
digits of the dialed number.
For example, in order to record only international outgo-
ing calls, you must program the digits "00."
The maximum number of digits is 4.
In the default setting a digit sequence is not configured.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
1 6 7
Enter the sequence of digits (up to 4) for the numbers
to be recorded.
Wait for a confirmation tone.
Initial state for Programming Mode.

Call Detail Report through Serial

Interface

This setting specifies if Call Detail Report will be done
through a serial interface or a modem.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
0 0 6
or
Activate/Deactivate Call Detail Report through a serial
#
interface:
= To activate
*
= To deactivate (default)
#
Initial state for Programming Mode.
Incoming calls with Caller ID at the source are
recorded at the beginning of the call.
Caller ID service must be contracted with a local
carrier.
Call Detail Report Manager
127