Recall/Urgent Call Activation After Timeout; Caller Id By Name/Number - Siemens HiPath 1100 Programming Manual

Programming an Extension
Step by Step
66
Recall/Urgent Call Activation after
Timeout
When an extension or external number (on an ISDN dig-
ital line) is busy, this configuration allows you to set a
timeout for activating the Recall or Urgent Call features
after approximately 7 seconds.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
0 3 7
or
* Activate/Deactivate the features:
#
* = To activate Recall and deactivate Urgent Call
= To deactivate Recall and activate Urgent Call
#
Initial state for Programming Mode.

Caller ID by Name/Number

This feature enables Caller ID information to be dis-
played on an extension's telephone display.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
0 3 9
... Select the information to be shown on the display:
1 3
1 = Name and number (default)
= Name only
2
3 = Number only
Initial state for Programming Mode.
When the ""Call Deflection" on page 144" feature
(Code 228) is activated, external Call Forwarding
to an extension that is a member of a group
should not be used. (does not work with analog
lines)
In this case the system does not receive any in-
formation about the forwarded call having been
answered or not. Since the system does not
have this information, it continues to signal all
other group members.
(default)