Electrical Connections - Teledyne VISION G2 CLASSIC 6 User Manual

Power
On
Off
Power
port
Vision G2 Testers User Guide—74-108-800 Rev. H—12 June 2019

Electrical Connections

Fig. C-4 Vision G2 (Classic 6 and Elite 8) Back Panel Ports
Fig. C-5 Vision Heater Back Panel Ports
This section provides instructions on making the power
connections to the Vision tester.
1. Ensure the power switch located on the right side of
the Vision tester is in the off (O) position.
2. Connect the power supply to the port labeled Input
on the back panel of the Vision tester, and the other
end to a power source.
3. Ensure the power switch located on the back of the
heater is in the off (O) position.
4. Insert the power cable into the back of the heater,
and the other end to a power source.
Installation
28 of 158
Power
port