Sms Diagnostics Examples - NetComm NWL-15 User Manual

SMS diagnostics examples

The examples below demonstrate various combinations of supported commands. This is not an exhaustive list and serves as an
example of possibilities only.
DESCRIPTION
Send SMS to change the data
connection username
Send SMS to change the data
connection password
Send SMS to change the data
connection authentication
Send SMS to reboot
Send SMS to check the WAN IP
address
Send SMS to check the mobile
signal strength
Send SMS to check the MEID
number
Send SMS to check the current
band
Send SMS to Disconnect (if
connected) and reconnect the data
connection
Send SMS to disconnect the data
connection
Send SMS to connect the data
connection
Send multiple get command
Send multiple set command
Send SMS to reset to factory default
settings
Send SMS to retrieve status of
router
Send SMS to retrieve the history of
the session, including start time, end
time and total data usage
Send SMS to configure the router to
send syslog to a remote syslog
server
Send SMS to wake up the router,
turn on the default gateway and
trigger the 'connect on demand'
profile if in waiting state.
Send SMS to perform firmware
upgrade when firmware is located
on HTTP server
Send SMS to perform firmware
upgrade when firmware is located
NetComm Wireless Light Industrial M2M Router Plus
98
AUTHENTICATION
Not required set username='NetComm'
Required PASSWORD set username= "NetComm"
Not required set password= `NetComm`
Required PASSWORD set password= `NetComm`
Not required set authtype= 'pap'
Required PASSWORD set authtype = pap
Not required execute reboot
Required PASSWORD execute reboot
Not required get wanip
Required PASSWORD get wanip
Not required get rssi
Required PASSWORD get rssi
Not required Get meid
Required PASSWORD get meid
Not required get band
Required PASSWORD get band
Not required execute pdpcycle
Required PASSWORD execute pdpcycle
Not required execute pdpdown
Required PASSWORD execute pdpdown
Not required execute pdpup
Required PASSWORD execute pdpup
Not required get wanip;
Required PASSWORD get
Not required set ssh.genkeys=1; set username=test; set auth=pap
Required PASSWORD set ssh.genkeys=1; set username=test; set auth=pap
Not required execute factorydefaults
Required PASSWORD execute factorydefaults
Not required get status
Required PASSWORD get status
Not required get sessionhistory
Required PASSWORD get sessionhistory
Not required set syslogserver=123.209.5.68
Required PASSWORD set syslogserver=123.209.5.68
Not required execute wakeup
Required PASSWORD execute wakeup
execute download
Not required
execute download
PASSWORD execute download
Required
PASSWORD execute download
http://download.com:8080/firmware_image_r.cdi
execute download
Not required
ftp://username:password@download.com/firmware_image.cdi
INPUT EXAMPLE
get rssi
wanip; get rssi
http://download.com:8080/firmware_image.cdi
http://download.com:8080/firmware_image_r.cdi
http://download.com:8080/firmware_image.cdi
www.netcommwireless.com