Geofence - NetComm NTC-223 User Manual Appendix

Geofence

Geofence allows you to designate a circular area and then uses the router's GPS position to monitor when the
NTC-223 router moves out of or into that area. You can configure notifications to be sent when the unit enters or
exits the region. Notifications types are set on the Event notification configuration page, see below.
To access the Geofence screen, select the Services item from the top menu bar then the GPS item on the left.
Finally, select Geofence from the sub-menu.
Set the Geofence operation toggle key to the ON position as in the screenshot below.
Geofence operation button
Save button
Add button
Geofence list
Display DMS /
Display Decimal degree
button
Display imperial /
Display metric button
Status
Optional GPS functionality on NTC-223 – User Guide Appendix
UG01192 v1.0 20 August 2019
Figure 9 – Geofence options
I T E M
Toggles Geofence operation ON or OFF.
When ON, your currently defined Geofences appear in the
Geofence list, see below.
Saves any changes made on this page
Click to add a new Geofence definition.
The Geofence configuration screen will open, see next
section below.
This table contains all your currently defined Geofences.
Toggle the Latitude and Longitude coordinates display
between Decimal degree coordinates, see above graphics,
or the more traditional DMS (degrees, minutes, seconds)
coordinates, see below:
Toggle between metric (kilometres) or imperial (miles)
display of the radius of the Geofence.
In if the router is inside the radius.
Out if the router is outside the radius.
D E S C R I P T I O N
10 of 13
© NetComm Wireless 2019