Groen CC20-E Operator's Manual page 307

Maintenance
Cleaning System Components
Removal
1. Turn off oven power.
2. Remove front clamp from auto clean tank (1).
3. Remove tank cap.
4. Pull front of tank through table, then remove tank rear hanger (2).
5. Remove tank from oven.
6. Disconnect water hoses from eductors (3) and remove eductors.
7. Replace adapters (4) if damaged.
8. Remove check valves (5).
Installation
1. Wrap male pipe threads with pipe thread tape (teflon tape).
2. Install check valves (5), male adapters (4), eductors (3), and auto clean tank
(1) in the reverse order of removal.
(Revised 1/02)
8-63