(Revised 1/02)
Drain Temperature Probe
Installation
(continued)
5. Connect oven to the branch circuit.
6. Turn on oven power and perform the following reset procedure:
a) Turn off oven power by pressing the ON touch pad.
b) While pressing the COMBO touch pad, press the ON touch pad.
If no errors are found, the unit will beep and show four zeros in the Time
display window. If errors are found, the unit will not beep and service code
will be displayed in the Time window. If there are more than four different
errors at one time, some of the numbers will be displayed in the Cook
Temperature window.
c) Press the CLEAR touch pad. Select Combo mode.
d) If the Service light comes on and service codes are displayed, record the
service code number or numbers. Press the CLEAR touch pad and repeat
steps a and b.
e) If the Service light does not come on, the oven should be ready for
operation.
Maintenance
Replacement Procedures
8-19
Need help?
Do you have a question about the CC20-E and is the answer not in the manual?