Eprom ( - Groen CC20-E Operator's Manual

Service Code Information Block
Code 4: Indicates a problem in the air temperature probe circuit.
ASK THE CUSTOMER:
CAN OVEN BE
OPERATED BEFORE
SERVICE?
PARTS TO TAKE ON
SERVICE CALL:
Description
Air Temperature Probe Kit
Drain/Air Temperature
Probe Wire Harness
Relay Board
Control Panel
Single Oven
Cook Only
Cook and Hold
Double-Stacked
Top, Cook Only
Bottom, Cook Only
Top, Cook and Hold
Bottom, Cook and Hold
EPROM
(Revised 1/02)
If service code 4 is displayed, refer to the following information block and
troubleshooting table. Read the information block before making a service call,
and use Table 4 if a service call is required.
Ask the customer to reset the solid state controls (see page 6-3). Select
Oven mode. If code 4 reappears, a service call is required. Also ask the
customer for the oven type (model and serial numbers) and what type of
control panel is installed on the unit (Cook only, or Cook and Hold option).
If the unit is a CC10-E, find out if it is a single or double-stacked unit.
Remember, for the CC10-E ovens, control panels cannot be interchanged
between single and double-stacked ovens, nor can they be interchanged
between the upper and lower ovens of a double-stacked unit.
Yes, in Steam mode only.
NOTICE: Be sure to take the Service Manual and the T-Cal Box (old electronics)
(P/N 074821) with you on the service call. Use only Groen Certified parts.
CC10-E
071235
073273
112966
112960
112961
112960
112960
112961
112961
112954
SERVICE CODES
Part Number
CC20-E CC10-G
071235 *090827
076495 085172
112964 112964
112960 112960
112961 ________
112960 112960
112960 112960
112961 ________
112961 ________
112955 112957
Service Code 4
CC20-G
090827
090705
112964
112960
_______
112960
112960
________
________
112957
6-15