Single Oven - Groen CC20-E Operator's Manual

Service Code Information Block
Code 9 indicates the boiler temperature probe circuit is not working properly.
ASK THE CUSTOMER:
CAN OVEN BE
OPERATED BEFORE
SERVICE?
PARTS TO TAKE ON
SERVICE CALL:
Description
Water Level Probe (Qty. 2)
Water Level Probe Harness
Relay Board
Boiler Temperature Probe Kit
Control Panel

Single Oven

Cook Only
Cook and Hold
Double-Stacked
Top, Cook Only
Bottom, Cook Only
Top, Cook and Hold
Bottom, Cook and Hold
EPROM
(Revised 1/02)
If service code 9 is displayed, refer to the following information block and trou-
bleshooting table. Read the information block before making a service call, and
use Table A if a service call is required.
The boiler and probes may be dirty. Ask the customer to reset the solid
state controls (see page 6-1), then refer to the Operating Manual for proper
cleaning instructions.
If code reappears, a service call is required. Verify oven type (ask for
model and serial numbers). Also ask the customer what type of control panel
is on the unit (Cook only, or Cook and Hold option.) If the unit is a double
stacked CC10-E, find out what control panel is currently on each oven.
Remember, for the CC10 E ovens, control panels cannot be interchanged
between single and double stacked ovens, nor can they be
interchanged between the upper and lower ovens of a double-stacked unit.
Yes. Oven mode only. The oven requires at least one good water level probe
to operate in STEAM or COMBO mode.
NOTICE: Only use Groen Certified Parts.
CC10-E
070178
073268
112966
077804
112960
112961
112960
112960
112961
112961
112954
SERVICE CODES
After Serial Number GC7243MS and C7439MS
Part Number
CC20-E CC10-G
070178 070178
076494 076494
112964 112964
083416 085187
112960 112960
112961 ________
112960 112960
112960 112960
112961 ________
112961 ________
112955 112957
Service Code 9
CC20-G
070178
090703
112964
085187
112960
_______
112960
112960
________
________
112957
6-25