Maintenance
Replacement Procedures
Door
Removal
1. Turn off oven power.
2. Allow oven to cool.
3. Remove door using one of the following two methods:
• Support weight of the door and remove hinge pin.
• Support weight of the door and remove the door-to-hinge bolts.
4. Place door on a flat, clean table or similar support, with gasket facing up. Be
careful not to scratch door surface.
Installation
1. Apply NEVER-SEEZ lubricant to hinge pin. Align door with hinge and insert
hinge pin.
Apply Loctite 242 to the door-to-hinge bolts, then install door and mounting
bolts. Do not tighten mounting bolts at this time.
2. Align door to oven. See page 8-5.
8-30
OR
OR
(Revised 1/02)
Need help?
Do you have a question about the CC20-E and is the answer not in the manual?