Door Switch - Groen CC20-E Operator's Manual

Hide thumbs Also See for CC20-E:
Table of Contents

Advertisement

(Revised 1/02)
Drain Valve
(continued)
7. Clean and install the valve. Repeat steps 1 through 4. If valve still
does not operate correctly, and there are no problems with K15 relay
operation and the drain line, disconnect the oven from the branch
circuit and replace the drain valve.

Door Switch

Be sure oven is disconnected from branch circuit power
before performing any repair work.
1. Disconnect oven from the branch circuit.
2. Disconnect door switch wires from the relay board.
3. Check continuity of each switch lead to chassis ground. If a short
circuit is measured, there may be a pinched wire causing an
insulation break. Replace the door switch if either lead is a short
circuit to ground.
4. If there is no problem in step 3, close the oven door and measure
continuity between the switch leads. You should measure a short
circuit.
5. Open oven door. The meter should indicate an open circuit.
6. Close the oven door. The meter should indicate continuity BEFORE
the door is fully latched.
7. If short and open circuits are not measured in steps 4 and 5, remove
the door latch assembly and check if door magnet is in the correct
location.
8. If the door magnet is not correctly installed, place it in the correct
position shown in this illustration, and repeat steps 4 and 5.
9. If necessary, replace the door switch as described on page
Door Alignment
1. Place a piece of masking tape over the door pin (bullet) hole in the
door.
2. Close the door until the door pin just penetrates the masking tape.
Make sure the door pin contacts only the door latch spring.
3. If door pin does not strike the center of the masking tape or spring
hole in the U-channel, loosen the hinge-to-oven bolts and align the
door to the door pin. Tighten hinge-to-oven mounting bolts.
Maintenance
Test and Adjustments
WARNING
8-5

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CC20-E and is the answer not in the manual?

This manual is also suitable for:

Cc10-eC/2gCc10-gCc20-gC/2-e

Table of Contents

Save PDF