FujiFilm PROFECT CS Service Manual page 1211

3.2 Image/Conveyance Checks
u NOTE u
Because the "MENU" and so forth differ depending on the IP type, image checks
should be performed with the "MENU" specified below.
1.
Record the IP, which was exposed as instructed in "3.1 Check Before
Procedures," under the following film output conditions, and output it.
l "ST/HR" IP
Film output conditions: "TEST", "Image Format" or "Image Format - 2", "SINGLE"
l "ST-BD" IP
Film output conditions: "TEST", "Image Format" or "Image Format - 2", "SINGLE"
l "HR-BD" IP
Film output conditions: "TEST", "Image Format" or "Image Format - 2", "SINGLE"
011-202-08E
09.30.2009 FM5540
2
Verify that there is no "unusual nonuniformity" found on the output
film or on the image displayed on the image monitor.
CHECK
u u
There should be no uneven density difference in the main scan direction.
If there is any uneven density difference, compare the films outputted from the
two IPs of the same size, and determine whether such nonuniformity is caused
by the machine or X-ray tube.
l If there is uneven density difference in the same direction on two films
→ The machine may be the cause of such nonuniformity.
{Troubleshooting}
l If positions of uneven density difference are different
→ The X-ray tube may be the cause of such nonuniformity.
CR-IR 363 Service Manual
PM-10
PM-10