All Sensor Led On - FujiFilm PROFECT CS Service Manual

[6-7]

All Sensor LED ON

n Function
Turn ON all the sensor LEDs to enable the LED display on the SNS17B board.
It is used to check the sensor via the LED display on the SNS17B board.
When the power of the RU is turned OFF, this setting is canceled.
CAUTION
After completion of sensor checkout, be sure to turn OFF the RU power. If all
the sensors are ON, an image abnormality occurs due to the influence of the
sensor LEDs.
REFERENCE
Confirm the IP leading edge sensor (SZ1) status with an LED on the scanner board.
- For CR-IR 362
{MD:4.1.6_LED Indications of I/O Status}
011-202-08E
09.30.2009 FM5540
n Procedures
1.
Put the RU in the Maintenance Mode.
Start the User Utility.
{MU:2.2.1_Starting the User Utility}
2.
Start the MUTL.
{MU:5.2.1_Starting the MUTL}
3.
Select All Sensor LED ON.
4.
Exit the MUTL.
{MU:5.2.2_Exiting the MUTL}
5.
Turn OFF and back ON the power of the RU.
CR-IR 363 Service Manual
MU-115
MU-115