Copying The Ctl And Digital Audio Signals; Connecting Only The Audio Signal And Time Code Signal Through The Pcm-3348Hr Units - Sony PCM-3348HR Operation Manual

8-3 Copying the CTL and Digital Audio Signals

8-3-1 Connecting Only the Audio Signal and Time Code Signal through
the PCM-3348HR Units
Connections
Turn off the power to all units before making the connections.
Master unit
PCM-3348HR
(recorder)
REMOTE-3
TAPE
RECORDER
RM-3348HR
Procedure
Use the following procedure to copy the CTL and digital
audio signals.
1
Mount the original tape on the player unit and set
the MASTER SAFE switch on the PCM-3348HR
system control block to the ON position.
2
Mount a blank tape on the recorder unit and set the
switches and buttons as follows:
• MASTER SAFE switch: OFF
• Fs switch: Sampling frequency of the original tape
• WORD LENGTH switch: Word length of the
original tape
• TIMER MODE button: CTL ABSOLUTE
• REC MODE switch: ADVANCE
8-4
Chapter 8 Backup Copy
A1
Analog audio signal
INPUT
A2
Analog audio signal
INPUT
TIME CODE
Time code signal
INPUT
MADI
Digital audio signal
INPUT
WORD SYNC
Word sync signal
OUT
SECTOR
SYNC
Sector sync signal
OUT
SECTOR
ADDRESS
Sector address signal
OUT
IEEE Std.
IEEE-488 bus signal
488-1978
Connections for copying the CTL and digital audio signals (1)
A1
OUTPUT
A2
OUTPUT
TIME CODE
OUTPUT
MADI
OUTPUT
REMOTE-3
WORD SYNC
IN
SECTOR
SYNC
IN
SECTOR
ADDRESS
IN
IEEE Std.
488-1978
• INPUT SELECT switch: DIGITAL
• SDIF-2/MADI switch: MADI
• TIME CODE selection switch: EXT or REGEN
(EXT)
3
On the recorder, set CTL to the starting point
address on the original tape, and record the CTL
for about 30 seconds in advance mode.
4
Set the REC MODE switch on the recorder to
ASSEMBLE.
5
Locate both recorder and player tapes at the CTL
address start point.
Slave unit
PCM-3348HR
(player)
TAPE
RECORDER
RM-3348HR