3-1 Channel Settings
Switching the monitor output automatically, depending on the tape transport state
Press and light the AUTO INPUT button, and the
monitor output will switch automatically depending on
the tape transport state as shown in the following table.
REC READY
Digital audio
channel
SAFE
REC READY
Analog audio
channel
SAFE
(AUTO REC: off)
Analog audio channel (AUTO REC: on)
Operating examples when the AUTO INPUT button is on
(insert/assemble recording mode)
Operations
Tape transport
REC READY
operation
operation
Off
STOP
PLAY
REC
On
PLAY
LOCATE
PLAY
Off
On
REC
PLAY
Off
STOP
a) In advance recording mode in these cases the playback
signal is output.
In insert recording mode and assemble recording mode, if
the monitor is set to REPRO for channels being recorded,
both REPRO and INPUT buttons on the remote control
unit light, but the monitor output is the input signal.
Setting all digital audio channels to the muting signal recording state
Press and light the ALL CHANNEL REC MUTE
button.
To release the muting signal recording state, press the
ALL CHANNEL REC MUTE button again to that it
goes dark.
3-2
Chapter 3 Basic Operations
Monitor output signal and tape transport state
REC
REH
Input signal
a)
Input signal
Playback signal
Playback signal
Input signal
a)
Playback signal
Playback signal
Playback signal
Input signal
Input signal
Monitor output
Playback signal
Input signal
Playback signal
a)
Input signal
Playback signal
Input signal
Playback signal
a)
Input signal
Playback signal
Tape transport state
PLAY
FF/REW
a)
Playback signal
Input signal
Playback signal
Playback signal
Playback signal
Input signal
Playback signal
Playback signal
Input signal
Input signal
STOP
Input signal
Playback signal
Input signal
Playback signal
Playback signal