Playback Signal Output Timing With A Mixing Console - Sony PCM-3348HR Operation Manual

11-2 Playback Signal Output Timing with a Mixing
Console
There are two timing modes for outputting the
playback signal.
m o d e o u t p u t • N o r m a l
The playback signal is output with a delay equal to
the time for digital signal processing, so that there is
no phase difference between the signal being
recorded and the playback signal.
m o d e o u t p u t • A d v a n c e d
The playback signal is output with a timing ahead of
that for normal output mode.
Normal output mode
Use this mode to carry out insert recording or assemble
recording with the playback signal using an analog
mixing console while monitoring the playback signal.
Since there is no phase difference between the
recording signal and playback signal, you can monitor
the cross fade from the playback signal
signal at a punch-in point.
11-6
Chapter 11 System Configuration
Selecting normal output mode
Use the following procedure.
to the input
1
Set the OUTPUT ADV/NORM switch on the
PCM-3348HR ARP board to NORM.
This causes the analog audio channel playback
signals to be output in normal output mode.
2
Set the D-OUT ADV/NORM switch on the PCM-
3348HR ED-2 board to NORM.
This causes the digital audio channel playback
signals to output in normal output mode.
ARP board ED-2 board
INPUT
LEVEL
A1
+
–
A2
– +
OUTPUT
LEVEL
A1
+
–
A2
– +
PWM
BIAS
COMPANDOR
OFF
NORM
OUTPUT
ADV
OUTPUT
NORM
ADV/NORM
LEVEL
switch
+
–
PHONES
ARP
Selection normal output mode
NORM E-E
D-OUT
D-OUT
NORM ADV
ADV/NORM
switch
ED-2