Out Point; Carrying Out Rehearsal And Time Shift Editing - Sony PCM-3348HR Operation Manual

5-10 Time Shift Editing
5-10-3 Saving the Punch-In Point
and Punch-Out Point
Use the following procedure to save the punch-in point
and punch-out point.
1
Listening to playback sound from the tape, press
the CUE STORE button at the point to begin
copying to the destination channel.
This saves the copy start point address in the cue
point register.
2
Press and light the RECALL button, then enter the
number of the cue point register used in step
the numeric buttons.
This displays the address saved in step
LOCATE TIME display.
3
Press the STORE and IN buttons in that order.
This saves the address saved in step 1 as the
punch-in point address in the IN point register.
4
Press the RECALL, IN, +, RECALL, SOUND
MEMORY, =, STORE, and OUT buttons, in that
order.
This adds the memory playback time to the address
of the punch-in point, saving the result as the
punch-out point in the OUT point register.
5
Press the RECALL, IN, STORE and MEM PLAY
buttons in that order.
This saves the punch-in point as the sound memory
playback start point (value of PS).
5-24
Chapter 5 Time Shift Editing Using the Sound Memory
5-10-4 Carrying Out Rehearsal
Use the following procedure to carry out time shift
editing.
1
Press the MODE button repeatedly until the
channel display shows "Au."
This means that the sound memory operation mode
is the auto start mode.
2
Press the MEM PLAY button.
1 on
The MEM PLAY lamp flashes, and the RM-
3348HR enters the sound memory playback
standby state.
1 in the
3
Press the REPRO button for the destination
channel.
4
Press the AUTO PUNCH button.
The tape begins playback from the preroll point,
and carries out a rehearsal between the punch-in
point and punch-out point.
At the punch in point, the destination channel
playback signal fades out, while the sound memory
playback signal fades in, and then at the punch-out
point, the sound memory playback signal fades
out, while the destination channel playback signal
fades in.
Use the rehearsal function to check the editing
effect, and as necessary adjust the cross fade time
(see Section 3-2, "Setting the Cross Fade Time")
or editing points (see Section 5-10-5, "Adjusting
the Editing Points").
5
Holding down the REC button, press the AUTO
PUNCH button.
This records the playback signal from sound
memory on the destination channel between the
punch-in point and punch-out point.
and Time Shift Editing