Sony PCM-3348HR Operation Manual page 239

f S Y N C C L O C K l
a m p s
These indicate which reference signal is being used for
synchronization.
I N T : Internal master clock
EXT: Signal input via the WORD SYNC INPUT
connector on the PCM-3348HR rear panel
DI: Signal input via the AES/EBU D-I connector on
the rear panel of the PCM-3348HR
REMOTE 3: signal input via the RM-3348HR
VIDEO: composite video signal input via the
REFERENCE VIDEO INPUT connector on the
rear panel of the PCM-3348HR.
g
C L O C K E X T ( e x t e r n a l ) E R R O R l a m p
When the PCM-3348HR SYNC CLOCK switch is set
other than to INT, this lights in the following cases:
•
When the selected reference signal is not input.
•
When the selected reference signal is input, but
synchronization is not possible.
In these cases, the SYNC CLOCK lamp corresponding
to the selected reference signal flashes.
h E M P H A S I S M I S M A T C H l
a m p
This lights when the emphasis information recorded on
a tape does not agree with the EMPH switch setting on
the PCM-3348HR.
i
S Y S T E M l a m p s
WARNING: This lamp lights when there are
particular combinations of settings on the PCM-
3348HR.
For details, see Section 12-2-5, "If the SYSTEM
WARNING Lamp Lights" (page 12-6).
ALARM: This lamp lights when there is a fault in the
PCM-3348HR.
For details, see Section 12-2-6, "If the SYSTEM
ALARM Lamp Lights" (page 12-6).
Time displays
1 Timer mode lamps
2 LOCATE TIME display
CTL
TIME CODE
RELATIVE
ABSOLUTE
TIMER
6 Time transfer buttons
1
l a m p s m o d e T i m e r
These indicate the type of time values being shown on
the TAPE TIME display and LOCATE TIME display.
C T L : CTL address
T I M E C O D E : Time code
R E L A T I V E : CTL relative value
ABSOLUTE:
TIMER: Timer roller counter value
2
L O C A T E T I M E d i s p l a y
This shows a time value saved in a register or input
with the numeric buttons. It also displays warning
indications.
3
T A P E T I M E d i s p l a y
Depending on the setting of the timer display mode,
this shows the tape transport time, the CTL address or
time code value recorded on the tape, the time code
value produced by the time code generator, or the
timer roller counter value.
4
l a m p f r a m e ) ( d r o p D F
This lights when the drop frame mode si selected for
the time code.
5
d i s p l a y s C U E
These show the registers used for storing or retrieving
cue points.
6
b u t t o n s r t r a n s f e T i m e
↓ : Transfers the value from the TAPE TIME display
to the LOCATE TIME display.
↑ : transfers the value from the LOCATE TIME
display to the TAPE TIME display.
3 TAPE TIME display
4 DF lamp
TAPE TIME CUE
DF
H MIN SEC
LOCATE TIME CUE
H MIN SEC FRAME mSEC
5 CUE displays
Time displays
CTL or time code absolute value
Appendixes
SF
A-31