Executing Auto Punch In/Out - Sony PCM-3348HR Operation Manual

4-4-4 Executing Auto Punch
In/Out
EXT CLOCK
SYNC CLOCK ERROR
EXT DI REMOTES VIDEO
SLAVE TIMER MODE
SF.mS 7 8
/F.S
TC CHASE CTL/TC
–
4 5
PRE ROLL POST ROLL
+
1 2
IN OUT
= +/- 0
SYNC OFFSET
– +
TRIM
º ‚ ·
REW FF PLAY
REC button

Executing auto punch in/out

Rehearsal using auto punch in/out
Press the AUTO PUNCH button.
Playback begins from the preroll point, and between
the punch-in point and punch-out point the rehearsal is
carried out, whereupon the tape stops at the postroll
point. The LOCATE TIME display shows the time
value for the punch-in point.
Carrying out a repeated rehearsal
Holding down the AUTO PUNCH button, press the
RTN button.
Both the buttons light, and the tape repeatedly travels
between the preroll and postroll points, repeating the
rehearsal between the punch-in and punch-out points.
Recording using auto punch in/out
Holding down the AUTO PUNCH button, press the
REC button.
Playback begins from the preroll point, and between
the punch in point and punch out point the recording is
carried out, whereupon the tape stops at the postroll
point. The LOCATE TIME display shows the time
value for the punch-in point.
RTN button
EMPHASIS
MISMATCH SYSTEM
WARNING ALARM
STORE RECALL
9
REP SET CUE STORE
6
3
CLEAR
RTN RLB
AUTO
LOC
PUNCH
π ®
STOP REC REH
AUTO PUNCH button
Preroll point for direct auto punch-in/out mode
• If the point where the AUTO PUNCH button was
pressed is before the punch-in point, the point at
which this button is pressed becomes the preroll
point.
The preroll time determined by this operation is
saved as the new value in the preroll time register.
• If the point where the AUTO PUNCH button was
pressed is after the punch-in point, the existing value
in the preroll time register is used to determine the
point to start playback.
Point where the AUTO
PUNCH button is pressed
New preroll time saved
Preroll point
Punch-in point
Previously saved
preroll time
Playback
Preroll point
Preroll point for direct auto punch-in/out mode
Preroll point for preroll auto punch-in/out mode
Regardless of the position where the AUTO PUNCH
button is pressed, the existing value in the preroll time
register is used to determine the point to start playback.
Chapter 4 Basic Operations of the RM-3348HR Remote Control Unit
Punch-in point
Previously saved
preroll time
Playback Recording or rehearsal
Point where AUTO
PUNCH button is pressed
Recording or rehearsal
4-17