Saving Punch-In/Out Points In - Sony PCM-3348HR Operation Manual

4-5 Continuous Auto Punch-In/Out
4-5-2 Saving Punch-In/Out Points
in Continuous Auto Punch
Mode
Saving punch-in/out points during
rehearsal or recording
In continuous auto punch mode, the punch-in/out
points are saved in IN/OUT-point register pairs 1
through 9 in numerical order.
Note
If there are some register pairs in which IN and OUT
points have already been saved, saving is executed
from the pair of the lowest number among those in
which IN/OUT points have not yet been saved.
Procedure
1
Set the channels for auto punch in/out to the
recording ready state.
2
Press and light the PLAY button to start playback.
3
At the point where you wish to start recording,
hold down the PLAY button, and press the REH or
REC button.
The REH or REC button lights, and the point at
which the button was pressed is stored in the IN-
point register which has the smallest number
among those in which an IN point has not yet been
saved, and displayed on the time data display as
follows.
TAPE TIME
CTL
TIME CODE
H
RELATIVE
LOCATE TIME
ABSOLUTE
TIMER
H
In point saved (example: 6 min. 00 sec.)
4-20
Chapter 4 Basic Operations of the RM-3348HR Remote Control Unit
Register number
CUE
DF
MIN SEC
CUE
MIN SEC FRAME mSEC SF
4
At the recording end point, press any tape transport
operation button (PLAY, FF, REW or STOP).
The REH or REC button goes off, and the point is
saved in the OUT-point register and displayed as
follows .
TAPE TIME
CTL
TIME CODE
H
RELATIVE
LOCATE TIME
ABSOLUTE
TIMER
H
Out point saved (example: 6 min. 30 sec.)
Repeat steps 1 through 4 to save up to IN/OUT
registers 9.
After saving in IN/OUT register 9 is completed, "reG
Full" appears on the LOCATE TIME display and no
more punch-in/out points can be saved.
Notes
• If you specify any point that is included in a already
registered block for the punch-in point in step
"O.V.L. (overlap)" appears on the LOCATE TIME
display and the point is not saved.
• If you specify any point that is included in an already
registered block for the punch-out point in step
"O.V.L." appears on the LOCATE TIME display,
and the point is not saved. The punch-in point that
was saved in step 3 is also cleared.
• When "O.V.L." is displayed, check the registered
punch-in/punch-out points as necessary (see
"checking the registered punch-in/out points" on the
next page) and save new points.
The "O.V.L." indication is cleared when a new point
is saved or by your pressing the CLEAR button.
Register number
CUE
DF
MIN SEC
CUE
MIN SEC FRAME mSEC SF
3,
4,