Sony PCM-3348HR Operation Manual page 24

2-5 Using the Timer
Selecting CTL relative mode
Use the following procedure to select CTL relative
mode.
1
Press the TIMER MODE button so that the CTL
RELATIVE lamp lights.
2
Run the tape, and stop it at the point to be used as
the reference point.
3
Press the RESET button.
The tape time display will change to "0:00:00."
With this setting, the tape time display now shows the
tape travel from the reference point.
Setting the time code absolute value display
mode
Use the following procedure to select the time code
absolute value display mode.
1
Press the TIMER MODE button so that the TIME
CODE lamp lights.
2
With the TIME CODE selector of the system
control block, select INT, EXT, or REGENE
(EXT).
3
If you selected INT in step 2, use the TC GEN
switch on the MC board to set the time code run
mode to FREE RUN or REC RUN.
TIME CODE
TC GEN
REC
RUN
OUTPUT
NORM
PB TC GAIN
NORM LOW
MC
MC board
Setting the timer roller counter mode
It is only possible to set the timer roller counter mode
by using the RM-3348HR.
2-16
Chapter 2 Preparations
TC GEN switch
FREE
RUN
ADV
To set on the RM-3348HR
Use the following procedure to set the timer display
mode using the RM-3348HR.
7 8 9
4 5 6
+ 1 2 3
= / 0 .
– +
Buttons use for setting the timer display mode
Use the TIMER MODE button and CTL/TC button to
set the timer display mode.
The following figure shows how to access the various
modes with these two buttons.
CTL/TC button
CTL/TC button
CTL absolute
display mode
TIMER MODE
button
TIMER MODE
button
How to access the various timer display modes
As the diagram shows, the CTL absolute mode is the
basic mode from which all other modes are accessed.
TIMER MODE
button
CTL/TC button
Time code
absolute
display mode
Time roller
+
counter mode
CTL relative
display mode