Sony PCM-3348HR Operation Manual page 234

Location and Function of Parts
2
s i g n a l D - O U T a u d i o N O R M / A D V ( d i g i t a l
h s w i t c o u t p u t ) a d v a n c e n o r m a l /
3
s w i t c h e s o u t p u t ) ( a d v a n c e A D V O U T
These switches determine the advance output of the
digital audio signal.
The D-OUT NORM/ADV switch is for selecting
advance output (ADV) or normal output (NORM).
Normally all eight individual bit switches of the ADV
OUT switches should be in the lower positions. This
represents a value of 255 words, the maximum
advance. Thus, the advance (in words) will be a sum
of the values assigned to the switches set to the lower
positions.
For a setting example, see "Setting the ADV OUT switches"
(page 11-8).
4
h e s s w i t c T e s t
These are for factory test purposes only. Do not
change the settings.
A-26
Appendixes
MT board
RESET
HOLD CALL
2SEC
NORM
MT
1
R E S E T s w i t c h
When the level meter display switch is set to HOLD,
pressing this switch resets the peak value being held.
2
h s w i t c a y d i s p l m e t e r L e v e l
This selects how the digital audio channel level meter
display operates as follows:
NORM: Operates as a peak program meter.
2SEC: Operates as peak program meter, but also holds
the peak value for approximately 2 seconds.
HOLD: Operates as a peak program meter, but also
holds the peak value when the RESET switch is
pressed.
CAL: Setting for calibrating A/D converter gain
1 RESET switch
2 Level meter display switch
SW4
SW3
4 SW4 switches
3 SW3 switches
MT board