Sony PCM-3348HR Operation Manual page 120

6-3 Selecting the Source and Destination Channels
Checking a specific channel selection
which is not displayed
1
Press the CH SET button.
The previously lit channel display starts flashing.
2
Press the lit one of the REPRO and REC READY
buttons for the channel you wish to check.
The channel pair including this channel appears in
the lower channel display, and the REPRO button
or REC READY button for each displayed channel
flashes.
3
After completing the check, press the CH SET
button again.
Note on deleting wrongly selected channels
When you press the REPRO button to check a source
channel in step 2 above, note that pressing the REC
READY button for the corresponding destination
channel deletes the source-destination channel pair.
Similarly, when you press the REC READY button to
check a destination channel in step 2 above, pressing
the REPRO button for the corresponding source
channel deletes the source- destination channel pair.
6-6
Chapter 6 Digital Copy
Changing the selected channels
The following is the procedure to change source
channel 3 to channel 1, by way of example.
1
Press the CH SET button.
The lower channel display flashes. Of the
channels selected, the REPRO button or REC
READY button flashes for those channels
are displayed, and is continuously lit for those
channels which are not displayed.
Flashing
STEREO SOUND MEMORY/DIGITAL COPY
DIGITAL COPY
SOURCE
SOUND MEMORY
CH
MEM MEM
PLAY STOP
Lit
S
SET UP MEMORY
REHEARSAL 2CH DIO RECALL
REC MUTE (REC DISABLE) SET UP ENABLE A B C
REC
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
REC
READY
REPRO
INPUT
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
REC
25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40
REC
READY
REPRO
INPUT
25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40
which
SCROLL
CH
MODE
SET
DESTINATION
CH
FWD/REV
BEFORE AFTER
INVERT
MEM START END
REC EDIT EDIT
DIGITAL AUDIO REMOTE CONTROL UNIT RM-3348HR
MONITOR MODE CONTROL X'FADE TIME
ALL ALL ALL REPRO AUTO X'FADE
EXT
D STORE INDIVIDUAL REPRO INPUT MUTE MUTE INPUT OUTPUT
CONTROLLED
AUTO REC REC
TIME
17 18 19 20 21 22 23 24 A1 A2
CODE
REC
READY
REPRO
INPUT
17 18 19 20 21 22 23 24 TIME A1 A2
CODE
ANALOG
MONITOR
REC
41 42 43 44 45 46 47 48
REC
READY
REPRO
INPUT
41 42 43 44 45 46 47 48
Flashing