Sony PCM-3348HR Operation Manual page 31

5
(1) Set the switches as follows.
TIMER MODE switch: TIME CODE
TIME CODE selection switch: INT
TIME CODE format selection switch: desired
format
TC GEN switch on the MC board: REC RUN
(2) Holding down the SET button, press the TIME
CODE REC READY button, to set the time
code channel to the recording ready state.
The TIME CODE REC READY button lights.
(3) Press and light the TIME CODE INPUT
button.
(4) Press the RESET button to reset the internal
time code generator to "00
6
Holding down the REC button, press the PLAY
button.
The REC lamps for all channels light, and
recording starts.
The signal level for each channel is displayed on
the respective level meter.
To set the CTL and time code start points to
desired values
In place of pressing the RESET button in step
enter a desired time value using the numeric buttons of
the RM-3348HR, then press the ↑ button.
The entered time value is sent to the tape time display
of the PCM-3348HR.
Using an external time code
In place of step 5 of the procedure "Using the internal
time code generator" use the following.
(1) Set the synchronizing signal to VIDEO using the
(2) Set the switches as follows.
(3) Holding down the SET button, press the TIME
00 00 ."
H MIN SEC
(4) Press the TIME CODE INPUT button to confirm
4 and 5,
SYNC CLOCK switch on the system control block
to synchronize the PCM-3348HR to an external
composite video signal.
• TIME CODE selection switch: REGENE (EXT)
or EXT
• TIME CODE format selection switch: Format of
the external time code
CODE REC READY button to set the time code
channel to the recording ready state.
The TIME CODE REC READY button lights.
time code input.
Chapter 3 Basic Operations
3-5