Selecting The Recording Port; To Be Controlled; Selecting The Audio Signals; Selecting The Video And Audio Signals To Be Monitored - Sony MAV-777 Operation Manual

4-1-2 Selecting the Recording Port

to be Controlled

Because the MAV-777 can handle up to three recording
ports, when making the various settings concerning
recording that are described later in this chapter it is first
necessary to specify which recording port is the target of
the setting. (Settings must be made individually for each
port.)
To select a recording port, press the PORT SELECT
button that corresponds to that port so that the button is lit.
PORT
SELECT Application Installed boards
button
P2/P3 Selecting the BKMA-720 and 730 2 input/2 output
R2 port
BKMA-720 × 2
P3/P2 Selecting the BKMA-720 × 2
R3 port

4-1-3 Selecting the Audio Signals

Set the AUDIO INPUT/MONITOR SELECT buttons as
follows, according to the audio input signals.
1
Press the PORT SELECT button to select the
applicable recording port.
2
Press the INPUT SELECT button, turning it on.
The AUDIO INPUT/MONITOR SELECT buttons
which are lit show the current selection.
3
Use the following buttons to select the input channels.
You can select input sources individually for each
channel.
• HD SDI CH1 to CH4 buttons:
signals input to the HD SDI INPUT connectors
(channels 1 to 4)
• AES/EBU CH1 to CH4 buttons:
signals input to the AUDIO INPUT (AES/EBU)
connectors (channels 1 to 4)
4-2 (E)
4-1 Preparations for Recording
4-1-4 Selecting the Video and Audio
This section describes how to select the video and audio
signals to be monitored.
Note
The video and audio signals in the monitor output are
those of the currently selected port.
Selecting the video signals to be
monitored
Port
configuration
The video signal of the currently selected port is output
from the HD SDI (SUPER), SD SDI (SUPER), and
ANALOG COMPOSITE (SUPER) connectors.
3 input/1 output
Character information is superimposed on the outputs
3 input/1 output
from these connectors.
For details of settings relating to the superimposed character
information, see Section 3-4-1, "Basic Menu Settings" (page 3-12).
Selecting the audio signals to be
monitored
Using the AUDIO INPUT/MONITOR SELECT buttons,
switch the audio signals output from the PHONES jack,
SD SDI (SUPER), and MONITOR OUTPUT L/R
connectors, as follows.
1
Press the MONITOR SELECT button, turning it on.
The AUDIO INPUT/MONITOR SELECT buttons
that are lit show the current monitoring selection.
2
Press the corresponding buttons, turning them on, to
select from channels 1 to 4 for the L and R monitoring
channels (a channel can be assigned to both L and R).
Notes
• The monitored audio signal uses the same port as the
video signal.
• Audio signals output from the SD SDI (SUPER)
connectors are as follows:
CH1: Audio monitor output. Same as the Lch signal.
CH2: Audio monitor output. Same as the Rch signal.
CH3: No output.
CH4: No output.
• Audio is not output from the HD SDI (SUPER)
connector.
To adjust the volume of the audio output from the
PHONES jack
Turn the PHONES control.
Signals to be Monitored