Selecting The Source And Destination Channels; Operation In Multi-Channel Mode - Sony PCM-3348HR Operation Manual

6-3 Selecting the Source and Destination Channels

Changing the channels during the input
operation
While the channel display is flashing, press the
REPRO button or REC READY button for another
channel.
Notes on channel settings in the digital copy
function
• It is not possible to set a channel other than the
destination channel in the recording ready state.
•
It is not possible to monitor the input signal of the
source channel or destination channel.
• The AUTO INPUT, ALL REPRO and ALL INPUT
buttons do not operate.
Changing or deleting channels after
completing the settings
Use the following procedure to change or delete
channels after completing the settings.
1
Press the CH SET button.
The upper or lower channel display flashes.
If the channel pair you wish to delete or change is
not flashing, press the CH SET button twice more.
This switches so that the other channel display
flashes.
2
To change the channels
Press the REPRO button for the new source
channel or REC READY button for the new
destination channel.
To delete the channels
Press the REPRO button for the source channel
whose display is flashing, then press the REC
READY button for the corresponding destination
channel.
3
After making the change or deletion, press the CH
SET button.
Deleting all channel pairs
Press the DIGITAL COPY button, turning it off.
6-4
Chapter 6 Digital Copy
6-3-2 Operation in Multi-Channel
Mode
This section describes the operations required for an
example operation in which the source and destination
channels are set as follows.
Source channel
3
9
17
Use the following procedure to make the above
channel settings.
1
Check that the DIGITAL COPY button is lit, and
that the points on the destination channel display
are lit.
Lit
STEREO SOUND MEMORY/DIGITAL COPY
DIGITAL COPY
SOURCE
SOUND MEMORY
CH
MEM MEM
PLAY STOP
Flashing
2
Press the REPRO button of the source channel (3)
and the REC READY button of the destination
channel (6).
The selected channel numbers appear flashing on
the lower channel display. To carry out a copy of
only a single channel, skip to step 5.
Lit
STEREO SOUND MEMORY/DIGITAL COPY
DIGITAL COPY
SOURCE
SOUND MEMORY
CH
MEM MEM MEM
PLAY STOP REC
Flashing
→
Destination channel
→
6
→
11
→
20
Lit
SCROLL
CH
MODE
SET
DESTINATION
CH
FWD/REV
BEFORE AFTER
INVERT
MEM START END
REC EDIT EDIT
SCROLL
CH
MODE
SET
DESTINATION
CH
FWD/REV
BEFORE AFTER
INVERT
START END
EDIT EDIT