Sony PCM-3348HR Operation Manual page 84

4-8 Setting the Preroll Time
4-8-2 Using Preroll Auto Punch
In/Out Mode
Use the following procedure to set the preroll time in
preroll auto punch-in/out mode.
6
SLAVE TIMER MODE
SF.mS
7
/F.S
TC CHASE CTL/TC
4
–
PRE ROLL POST ROLL
9
+
1
IN OUT
5
=
+/-
SYNC OFFSET
–
TRIM
º ‚ ·
REW FF PLAY
8 3
Using preroll auto punch-in/out mode to set the preroll time
1
Set switch No. 2 of the upper set of the
SELECTOR switches on the rear panel of the RM-
3348HR to ON (NORM).
This selects the preroll auto punch-in/out mode.
For details on the preroll auto punch in/out mode and
the position of the SELECTOR switches, see Section
4-4, "Auto Punch In/Out" (page 4-14).
2
Use the numeric buttons to display the time value
for a point approximately 20 seconds before the
punch in point on the LOCATE TIME display.
3
Holding down the LOC button, press the PLAY
button.
The tape automatically rewinds or fast-forwards to
that point, then begins playback.
4
Listening to the playback sound, press the CUE
STORE button at the point you wish to make the
preroll point.
This saves the selected position in the cue point
register.
4-30
Chapter 4 Basic Operations of the RM-3348HR Remote Control Unit
2,7
9
STORE RECALL
5,7
8 9
REP SET CUE STORE
4
5 6
2 3
0
CLEAR
RTN RLB
+
AUTO
LOC
PUNCH
π ®
STOP REC REH
5
Press the RECALL button, then the IN button, to
display the time value for the punch-in point saved
in the IN point register on the LOCATE TIME
display.
6
Press the – (minus) button.
7
Press the RECALL button, then enter the number
of the cue point register used in step 4 with the
numeric buttons to display the time value for the
preroll point on the LOCATE TIME display.
8
Press the = button.
This calculates the preroll time (punch-in point
minus preroll point), and displays it on the
LOCATE TIME display.
9
Press the STORE button, then the PREROLL
button.
This saves the preroll time.