Playback From Sound Memory - Sony PCM-3348HR Operation Manual

5-8-3 Using Auto Start Mode for

Playback from Sound Memory

Use the following procedure for playback from the
sound memory using auto start mode.
1
Use either of the following methods to save a tape
address in the PS register.
1) Play back from sound memory using manual
mode.
For details, see Section 5-8-2, "Using Manual Mode for
Playback from Sound Memory" (previous page).
The tape address at which you pressed the MEM
PLAY button is saved in the PS register.
2) Enter the required tape address on the LOCATE
TIME display using the numeric buttons, and
press the STORE and MEM PLAY button in
that order.
You cannot carry out playback from sound
memory in the auto start mode unless there is a
tape address in the PS register.
2
Press the MEM PLAY button.
The MEM PLAY lamp flashes, and the RM-
3348HR enters the sound memory playback
standby state.
STEREO SOUND MEMORY/DIGITAL COPY
DIGITAL COPY
SOURCE
SOUND MEMORY
CH
MEM MEM
PLAY STOP
Flashing MEM PLAY button
The tape address at which you pressed the MEM
PLAY button appears on the LOCATE TIME
display, and the CUE display shows "PS"
(indicating the sound memory playback start
point).
Lit
SCROLL
CH
MODE
SET
DESTINATION
CH
FWD/REV
BEFORE AFTER
INVERT
MEM START END
REC EDIT EDIT
TAPE TIME
CTL
TIME CODE
H
RELATIVE
ABSOLUTE
TIMER
H
Sound memory playback start point
3
Begin playback, recording or rehearsal of the tape
from before the target start address.
When the tape address shown on the TAPE TIME
display matches the value of PS shown on the
LOCATE TIME display, sound memory playback
from the sound memory editing start point (the
value in the SA register) begins automatically.
The MEM PLAY lamp changes from flashing to
constantly lit.
Auto start
mode indication
STEREO SOUND MEMORY/DIGITAL COPY
DIGITAL COPY
SOURCE
SOUND MEMORY
CH
MEM MEM MEM
PLAY STOP REC
Lit
Ending playback from sound memory while in
progress
Press the MEM STOP button.
The MEM PLAY lamp goes off.
If you do not press the MEM STOP button
during sound memory playback
The sound memory playback stops automatically at the
sound memory editing end point (the value in the EA
register).
For details on the sound memory editing end point (EA
register) see Section 5-3-2, "Sound Memory Editing Start
Point (SA) and End Point (EA)" (page 5-4).
Exiting the sound memory playback standby
state
Press the MEM STOP button.
The MEM PLAY lamp goes off.
Chapter 5 Time Shift Editing Using the Sound Memory Function
CUE
DF
MIN SEC
LOCATE TIME CUE
MIN SEC FRAME mSEC SF
Register name
Destination channels
(stereo signal)
SCROLL
CH
MODE
SET
DESTINATION
CH
FWD/REV
BEFORE AFTER
INVERT
START END
EDIT EDIT
5-19