Setting The Preroll Time; Using Direct Auto Punch In/Out Mode; Using Preroll Auto Punch In/Out Mode - Sony PCM-3348HR Operation Manual

4-8 Setting the Preroll Time

The preroll time is initially set to 8 seconds.
There are two methods, as follows, for changing the
preroll time.
•
Using direct auto punch-in/out mode
While listening to the playback sound, press the
AUTO PUNCH button before the punch-in point; the
point at which the button is pressed becomes the
preroll point for the auto punch-in/out operation.
• Using preroll auto punch-in/out mode
In this mode, after the time value for the preroll point
is saved in the cue point register, it is subtracted from
the punch-in point, and the preroll time thus obtained
is saved.

4-8-1 Using Direct Auto Punch In/Out Mode

Use the following procedure to set the preroll time in
direct auto punch-in/out mode.
REMOTE1,3,4 REMOTE2
/LOCAL
SYSTEM
CONTROL
POWER
Ø /ø
1
Set switch No.2 of the upper set of the
SELECTOR switches on the rear panel of the RM-
3348HR to OFF (A.PUNCH).
This selects the direct auto punch-in/out mode.
For details on the direct auto punch-in/out mode and
the position of the SELECTOR switches, see Section
4-4, "Auto Punch In/Out" (page 4-14).
2
Use the numeric buttons to display the time value
for a point approximately 20 seconds before the
punch-in point on the LOCATE TIME display.
LOCATE TIME display
WORD MASTER
SAMPLING FREQ REC MODE
LENGTH SAFE
24BIT 16BIT 44.056KHz 44.1KHz 48.0KHz ADVANCE ASSEMBLE INSERT
SYNC REC
REC
TAPE TIME
CTL
DF
TIME CODE
H MIN SEC
RELATIVE
LOCATE TIME
ABSOLUTE
TIMER
H MIN SEC FRAME mSEC
VARI SPEED CONTROL STEREO SOUND MEMORY/DIGITAL COPY
DIGITAL COPY
NORMAL %
SOURCE DESTINATION
SOUND MEMORY
CH CH
VARI HALF
SPEED TONE
VARI
H.T./%
SPEED
– +
VARI MEM MEM MEM
SET PLAY STOP REC
Using direct auto punch-in/out mode to set the preroll time
2 4
EXT CLOCK EMPHASIS
SYNC CLOCK ERROR MISMATCH
INT EXT DI REMOTES VIDEO
CUE SLAVE TIMER MODE
SF.mS 7 8 9
/F.S
TC CHASE CTL/TC
–
CUE 4 5 6
PRE ROLL POST ROLL
+
SF 1 2 3
IN OUT
= +/- 0
CLEAR
SCROLL
CH
SYNC OFFSET
MODE
SET
– +
TRIM
FWD/REV
BEFORE AFTER
INVERT
º ‚ · π
REW FF PLAY STOP
START END
EDIT EDIT
3
3
Holding down the LOC button, press the PLAY
button.
The tape automatically rewinds or fast-forwards to
that point, then begins playback.
4
Listening to the playback sound, press the AUTO
PUNCH button at the point you wish to make the
preroll point.
This calculates and saves the preroll time on the
basis of the selected preroll point.
Chapter 4 Basic Operations of the RM-3348HR Remote Control Unit
SYSTEM
WARNING ALARM
STORE RECALL
REP SET CUE STORE
RTN RLB
LOC
AUTO
PUNCH
®
REH
REC
4-29