Switching The Monitor Output - Sony PCM-3348HR Operation Manual

4-1 Audio Control

4-1-3 Switching the Monitor Output

There are three ways of switching the monitor output.
• Individual settings
You can select the monitor output individually for
each channel, using the REPRO buttons and INPUT
buttons.
• Using the AUTO INPUT button
Pressing and lighting the AUTO INPUT button
Individual settings
INPUT buttons
REPRO buttons
S
REC
REC
READY
REPRO
INPUT
REC
REC
READY
REPRO
INPUT
REPRO button
Press and light the REPRO button for a certain channel
to set the channel to the playback signal monitoring
state.
When the ALL MUTE button or REPRO MUTE
button is lit, the REPRO button for each channel is still
active, but does not light.
INPUT button
Press and light the INPUT button for a channel to set
that channel to the input signal monitoring state.
When the ALL MUTE button is lit, the INPUT button
for each channel is still active, but does not light.
Conditions where both the REPRO and INPUT
buttons light simultaneously
If all the conditions below hold, both the REPRO
INPUT buttons for a channel will be lit. In this case,
the monitor output is the input signal.
4-4
Chapter 4 Basic Operations of the RM-3348HR Remote Control Unit
SET UP MEMORY
REHEARSAL 2CH DIO RECALL
(REC DISABLE) SET UP ENABLE
REC MUTE A B
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40
25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40
Individual settings
causes the monitor output to be switched
automatically depending on the tape transport state.
• Using the MONITOR MODE CONTROL buttons
Using the ALL REPRO and ALL INPUT buttons,
you can select the playback signal or input signal for
all digital audio channels together.
DIGITAL AUDIO REMOTE CONTROL UNIT RM-3348HR
MONITOR MODE CONTROL
ALL ALL ALL REPRO
REPRO INPUT MUTE MUTE
C D STORE INDIVIDUAL
17 18 19 20 21 22 23 24
17 18 19 20 21 22 23 24
41 42 43 44 45 46 47 48
41 42 43 44 45 46 47 48
•
When the recording mode is "assemble recording" or
"insert recording."
•
When the tape transport state is "recording" or
"rehearsal."
•
When the REC READY and REPRO buttons for the
channel are both turned on.
Effect of the REPRO buttons and INPUT
buttons in the sound memory and digital copy
functions
In the sound memory function or digital copy function,
the REPRO buttons and INPUT buttons specify the
source channels for copying.
In this case, the REPRO buttons and INPUT buttons
flash to indicate the channels specified as the source.
For details on the channel settings for the sound memory
function, see Section 5-4-2, "Selecting the Source and
Destination Channels" (page 5-7), and for details on the
channel settings for the digital copy function, see Section 6-3,
"Selecting the Source and Destination Channels" (page 6-3).
X'FADE TIME
AUTO X'FADE
EXT
INPUT OUTPUT
CONTROLLED
REC
AUTO REC
TIME
A1 A2
CODE
REC
READY
REPRO
INPUT
TIME A1 A2
CODE
ANALOG
MONITOR
REC
REC
READY
REPRO
INPUT