Sony PCM-3348HR Operation Manual page 99

3
Turn the TRG INPUT LEVEL control knob on the
MEM board fully clockwise, and apply the trigger
signal to the TRG INPUT connector or SOUND
MEMORY TRIGGER INPUT connector, then turn
the TRG INPUT LEVEL control knob
counterclockwise until just before the TRG lamp
goes off.
Check that the TRG lamp lights when the trigger
signal is applied.
When the trigger signal goes active, the TRG lamp
lights, and the trigger is applied, to start the writing to
or playback from the sound memory, after a maximum
delay of one sector.
5-6-3 Inputting a Trigger Signal to
the RM-3348HR
SOUND MEMORY EXT TRIGGER IN connector
Inputting a trigger signal
Connect the trigger signal via the SOUND MEMORY
EXT TRIGGER IN connector on the rear panel of the
RM-3348HR. This is a switch contact type signal; that
is, it should normally be connected to a relay contact,
for example. A trigger signal connected via this
connector always operates in retriggerable mode.
When a trigger signal is connected both to the
PCM-3348HR and to the RM-3348HR
The trigger signal input to the RM-3348HR takes
precedence, as follows.
• If the signal input to the PCM-3348HR has triggered
sound memory playback, then if during sound
memory playback the signal input to the RM-3348HR
goes active even if the PCM-3348HR is in the non-
retriggerable mode, the signal retriggers.
• If the signal input to the RM-3348HR has triggered
sound memory playback, then if during sound
memory playback the signal input to the PCM-
3348HR goes active, regardless of whether the PCM-
3348HR is in the retriggerable mode or non-
retriggerable mode, no retriggering occurs.
Chapter 5 Time Shift Editing Using the Sound Memory Function
⁄AC IN
y
5-13