Using Registers To Save And Retrieve Time Values - Sony PCM-3348HR Operation Manual

4-6 Registers and the LOCATE TIME Display
Numeric buttons: Use these buttons to input a time.
The value scrolls from the right as you input it.
CLEAR button: Clears the value to all zeros.
+/– button: Reverses the sign of the time value.
Arithmetic function buttons: These function as on a
conventional calculator, except that they
operate in base 60, to give the appropriate
arithmetic for time values.
↓ button: This transfers the value on the TAPE TIME
display to the LOCATE TIME display.
TRIM buttons: These adjust the value by plus or
minus one. The correction unit is determined
by the setting of the SF.mS/F.S button setting
and the timer display mode as follows.
SF.mS/F.S Timer display mode
button setting
SF.mS Time code chase or
synchronized operation
CTL display mode
F.S Time code display mode
CTL display mode
4-6-3 Using Registers to Save and
Retrieve Time Values
Saving
PREROLL button
POSTROLL button
SLAVE TIMER MODE
SF.mS
/F.S
TC CHASE CTL/TC
–
PRE ROLL POST ROLL
+
IN OUT
= +/- 0
SYNC OFFSET
–
º ‚
REW FF
OUT button
SYNC OFFSET button
IN button

Using registers to save and retrieve time values

4-24
Chapter 4 Basic Operations of the RM-3348HR Remote Control Unit
Correction unit
Subframe
(1/100 frame)
Seconds
Frames
Seconds
STORE RECALL
7 8 9
REP SET CUE STORE
4 5 6
1 2 3
CLEAR
RTN RLB
+
TRIM
AUTO
LOC
PUNCH
· π ®
REH
PLAY STOP REC
Use the following procedure to save a time value.
1
Use the numeric buttons to input the time value
and show it on the LOCATE TIME display.
2
Press and light the STORE button, then enter the
required cue point register number using the
numeric buttons.
When up to 100 cue point registers can be used,
enter a two-digit number.
To select a special-purpose register, in place of the
numeric buttons, press one of the following
buttons:
• IN point register: IN button
• OUT point register: OUT button
• Preroll-time register: PREROLL button
• Postroll-time register: POSTROLL button
• Sync offset time register: SYNC OFFSET button
Retrieving
To retrieve a stored time value, press and light the
RECALL button, then enter the number of the
corresponding cue point register using the numeric
buttons.
To retrieve a value from one of the special-purpose
registers, in place of the numeric buttons, press the
corresponding button used in step
value in step 2.
For details on saving and retrieving values from registers
for the sound memory function, see Section 5-3, "Registers
for the Sound Memory Function" (page 5-3).
2 for saving the