Spot Erase Function - Sony PCM-3348HR Operation Manual

4-9 Spot Erase Function

Use the following procedure to record a muting signal
over a specific interval on the tape.
1
Press and light the REC READY button for the
digital audio channel you wish to spot erase.
2
Enter the start point and end point for the spot
erase as the punch-in/out points.
For details on setting the punch-in/out points, see
Section 4-4-1, "Saving Punch-In/Out Points During
Rehearsal or Recording" (page 4-15) and Section
4-4-2, "Saving Time Values Directly in the IN and OUT
Point Registers" (page 4-16).
3
Press the REC MUTE button so that it flashes.
4
Holding down the AUTO PUNCH button, press
the REC button.
A muting signal will be recorded between the
punch-in point and punch-out point.
Chapter 4 Basic Operations of the RM-3348HR Remote Control Unit
4-31