Playing Back From The Sound Memory; Preparations; From Sound Memory - Sony PCM-3348HR Operation Manual

5-8 Playing Back From the Sound Memory

5-8-1 Preparations

Before carrying out playback from the sound memory,
be sure to check that you have carried out the
preparations described in Section 5-7-1, "Preparations"
(page 5-14), and further check the playback direction
by simultaneously pressing the MODE button and
INVERT button.
For details on setting the playback direction, see Section
5-4-4, "Selecting the Sound Memory Playback Direction"
(page 5-10).
5-18
Chapter 5 Time Shift Editing Using the Sound Memory
5-8-2 Using Manual Mode for
Playback from Sound Memory
Use the following procedure for playback from the
sound memory using manual mode.
1
Press the INPUT button for the destination
channel.
2
Begin tape playback.
3
Press the MEM PLAY button.
The MEM PLAY lamp lights, and playback starts
from the sound memory editing start point (the
value in the SA register).
The tape address at which the MEM PLAY button
was pressed is saved as the sound memory
playback start point (in the PS register).
For details on the sound memory editing start point (SA
register) see Section 5-3-2, "Sound Memory Editing
Start Point (SA) and End Point (EA)" (page 5-4), and
for details on the sound memory playback start point
(PS register) see Section 5-3-1, "Sound Memory
Playback Start Point (PS)" (page 5-3).
Destination channel
STEREO SOUND MEMORY/DIGITAL COPY
DIGITAL COPY
SOURCE
SOUND MEMORY
CH
MEM MEM
PLAY STOP
Lit MEM PLAY button
Abandoning playback in progress
Press the MEM STOP button.
The MEM PLAY lamp goes off.
If you do not press the MEM STOP button
during sound memory playback
Playback ends after about 160 seconds for a mono
signal, and 80 seconds for stereo signal, and the MEM
PLAY lamp goes off.
Restarting playback in progress from the
beginning
Press the MEM PLAY button.
SCROLL
CH
MODE
SET
DESTINATION
CH
FWD/REV
BEFORE AFTER
INVERT
MEM START END
REC EDIT EDIT