Sony PCM-3348HR Operation Manual page 45

MC board
1 SELECT switch No. 4 (VARI SYNC)
OFF ON
BACK UP 1
AUTO REC 2
D10.NO.DLY 3
VARI SYNC 4
TEST
TIME CODE
TC GEN
2 TC GEN switch
REC FREE
RUN RUN
OUTPUT
3 OUTPUT switch
NORM ADV
PB TC GAIN
4 PB TC GAIN switch
NORM LOW
MC
MC board
1 SELECT switch No. 4 (VARI SYNC)
This selects whether the vari sync function is on or off
during time code sync playback.
When this switch is off, the sector sync function is
enabled.
2 TC GEN (time code generator) switch
Select the advancement mode for the time code.
REC RUN: The time code only advances while the
PCM-3348HR is actually recording.
FREE RUN: As long as the PCM-3348HR is powered
up, the time code advances irrespective of whether
or not it is recording.
3 OUTPUT switch
Select the output timing for the time code.
NORM: The time code is output at the in-line point.
ADV: The time code is output ahead of the in-line point.
4 PB TC (playback time code) GAIN switch
NORM: For normal use (factory-set position).
LOW: For playback of time codes recorded on the PCM-
3324A/3324.
In addition, you can turn the phase correction function
of the internal time code generator on and off with an
internal switch.
For internal settings of the board, see "MC board" (page A-
20) in Appendixes, "Location and Function of Parts."
TCR Board
1 PB REGENE LOCK lamp
LOCK
PB REGENE
ON
2 PB REGENE switch
OFF
CHASE MODE
ADRS
FREE
TC SYNC PLAY
ON
3 TC SYNC PLAY switch
OFF
TCR
TCR board
1 PB REGENE (playback time code regeneration)
LOCK lamp
This lights when a playback time code is input and is
being correctly regenerated. If the playback time code
ceases to be input, this lamp goes off even if
regeneration continues.
2 PB REGENE (playback time code regeneration)
switch
Select whether or not to regenerate the playback time
code.
ON: Regenerate the playback time code, and output it
from the TIME CODE OUTPUT connector.
OFF: Output the playback time code unaltered from
the TIME CODE OUTPUT connector.
3 TC (time code) SYNC PLAY switch
This enables or disables time code sync playback.
When using time code sync playback, use SELECT
switch No. 4 (VARI SYNC) on the MC board to set
the vari sync function on or off.
In addition, you can turn the time code interpolation
function in fast-forward and rewind modes on and off
and select the frame frequency for this function with
the internal switches.
For internal settings of the board, see "TCR board" (page
A-21) in Appendixes, "Location and Function of Parts."
Chapter 3 Basic Operations
3-19