4-5 Continuous Auto Punch-In/Out
Canceling the registered punch-in/out
points
Specify 0 (zero) for all the digits of the punch-in and
punch-out points in steps 1 and 3 of the procedure for
"Saving time values directly in the IN and OUT-point
registers" on the previous page, then specify the
number of the register to be cleared.
You can also cancel the punch-in and punch-out points
by pressing the CLEAR button after displaying the
time value in steps 1 and 3.
4-22
Chapter 4 Basic Operations of the RM-3348HR Remote Control Unit
4-5-3 Executing Continuous Auto
Punch In/Out
Auto punch in/out of all the registered blocks is
executed from the earliest punch-in point in the time
sequence.
Rehearsal using continuous auto punch in/out
Press the AUTO PUNCH button.
Playback begins from the preroll point for the first
section (with the earliest punch-in point), and rehearsal
is carried out between the punch-in point and punch-
out point. When rehearsal of the first section is
completed, the tape is played back up to the punch-in
point of the next section. When rehearsal of the last
section is completed, the tape stops at the postroll
point for the last section.
Recording using continuous auto punch-in/
out
Holding down the AUTO PUNCH button, press the
REC button.
Playback begins from the preroll point for the first
section (with the earliest punch-in point), and
recording is carried out between the punch-in point
and punch-out point. When recording of the first
section is completed, the tape is played back up to the
punch-in point of the next section. When recording of
the last section is completed, the tape stops at the
postroll point for the last section.