Recording Preparations And Operations; Selecting The Recording Source; Optional Hksr-101 Is Installed); Selecting Signals To Output To The Hd Monitor - Sony SRW-1 Operation Manual

5-2 Recording
Preparations and
Operations
Before recording, make the following preparations.
About connections for recording, see page 25.
Operation Menu item or
control
Select the recording VIDEO I/O in the
source input to the VIDEO Setup menu
SRPC-1 (when the
optional HKSR-101 is
installed).
Select whether or not PD(MON) in the
to perform pull-down VIDEO Setup menu
conversion for the
output to the HD
a)
monitor.
Select the audio INPUT SEL in the
signals to record. AUDIO Setup menu
Make settings for PHONE SEL in the
audio signals to AUDIO Setup menu
monitor.
Set the audio level METER TYPE in the
meter display range. AUDIO Setup menu
Set the recording REC LEVEL in the
audio level. AUDIO Setup menu
Adjust the level of Rotate the LEVEL
audio signals output knob of the
to the EARPHONES EARPHONES jack.
jack.
Cancel record inhibit REC INHI in the
if the system is set to SYSTEM Setup menu
record inhibit mode.
Select the type of TIMER SEL in the TC
time data to display. Setup menu
Make settings for the RUN MODE, TCG
timecode generator MODE, REGENE
depending on SOURCE in the TC
timecode and user bit Setup menu
data to record.
a) This selection is possible only when the frame frequency is 23.98PsF.
5-2-1 Selecting the Recording
Source (When Optional HKSR-
101 Is Installed)
When the optional HKSR-101 is installed in this unit,
select the input from the CAMERA connector (optical-
fiber connector) or the input from the HD SDI IN A/B
connectors.
1
Press the menu selection button "VIDEO".
The VIDEO Setup menu appears.
2
Rotate the SELECT/ENTER dial to select "VIDEO I/
O", and press the dial.
A settings window appears.
3
Rotate the SELECT/ENTER dial to select one of the
following, and press the dial.
Reference
CAM(Optical): Use the input signal from the
Page 53 CAMERA connector.
SDI Input: Use the input signal from the HD SDI IN
A/B connectors.
Page 53
5-2-2 Selecting Signals to Output to
the HD Monitor
Before recording video, first check it on the monitor.
When the frame frequency is 23.98PsF, in the VIDEO
Page 54
Setup menu, select whether or not to perform pulldown
conversion for the output to the MONITOR OUT HD SDI
Page 54
connector.
1
Press the menu selection button "VIDEO."
Page 55
The VIDEO Setup menu appears.
Page 55
Page 16
Page 19
Page 58
Page 56
Page 56
2
Rotate the SELECT/ENTER dial to select PD(MON),
then press the dial.
A setting window appears.
3
Rotate the SELECT/ENTER dial to select one of the
following, then press the dial.
AUTO: Pulldown conversion is performed if the
frame frequency is 23.98 Hz. Otherwise pulldown
conversion is not performed.
THRU: Pulldown conversion is not performed.
V I D E O S e t u p
PD(MON) AUTO
DC
C A S S O U T 00:0 0:00:00
S R W - 1 T C R

5-2 Recording Preparations and Operations

53