Configuring Optional Parameters For The Nqa Template - HPE FlexNetwork 5510 HI Series Network Management And Monitoring Configuration Manual

Step
4. (Optional.) Specify the
destination port number
for the operation.
5. (Optional.) Specify the
source IP address for the
probe packets.
6. Specify an SSL client
policy.

Configuring optional parameters for the NQA template

Unless otherwise specified, the following optional parameters apply to all types of NQA templates.
The parameter settings take effect only on the current NQA template.
To configure optional parameters for an NQA template:
Step
1. Enter system view.
2. Create an NQA template
and enter its view.
3. Configure a description.
4. Set the interval at which
the
repeats.
5. Set the probe timeout
time.
6. Set the TTL for probe
packets.
7. Set the ToS value in the
IP header
packets.
8. Specify the VPN instance
where the operation is
performed.
9. Set
consecutive
probes to determine a
successful
event.
10. Set
consecutive
failures to determine an
operation failure.
Command
destination port port-number
•
•
ssl-client-policy policy-name
Command
system-view
nqa template { dns | ftp | http
| https | icmp | ssl | tcp |
tcphalfopen | udp } name
description text
NQA operation
frequency interval
probe timeout timeout
ttl value
of probe
tos value
vpn-instance
vpn-instance-name
the number of
successful
reaction trigger probe-pass
count
operation
the number of
probe
reaction trigger probe-fail
count
IPv4 address:
source ip ip-address
IPv6 address:
source ipv6 ipv6-address
124
Remarks
By default, the destination port number
is not specified.
By default, the packets take the primary
IP address of the output interface as
their source IP address.
The source IP address must be the IP
address of a local interface, and the
interface must be up. Otherwise, no
probe packets can be sent out.
By default, no SSL client policy is
specified.
Remarks
N/A
By default, no NQA templates exist.
By default, no description is configured.
The default setting is 5000 milliseconds.
If the operation is not completed when the
interval expires, the next operation does
not start.
The default setting is 3000 milliseconds.
The default setting is 20.
The default setting is 0.
By default, the operation is performed on
the public network.
The default setting is 3.
If the number of consecutive successful
probes for an NQA operation is reached,
the NQA client notifies the feature that
uses the template of the successful
operation event.
The default setting is 3.
If the number of consecutive probe
failures for an NQA operation is reached,
the NQA client notifies the feature that
uses the NQA template of the operation