Displaying And Maintaining Poe; Poe Configuration Example - HPE FlexNetwork 5510 HI Series Network Management And Monitoring Configuration Manual

Step
1. Enter system view.
2. Upgrade the PSE firmware in service.

Displaying and maintaining PoE

Execute display commands in any view.
Task
Display PSE information.
Display the power supplying information for
the specified PI.
Display power information for PIs.
Display PSE information.
Display the power supplying information for
all PIs on a PSE.
Display power information for all PIs on a
PSE.
Display all information about the PoE profile.
Display all information about the PoE profile
applied to the specified PI.

PoE configuration example

Network requirements
As shown in
•
Enable the device to supply power to IP telephones and APs.
•
Enable the device to supply power to IP telephones first when overload occurs.
•
Allocate AP B a maximum power of 9000 milliwatts.
Figure 22 Network diagram
IP phone A
IP phone B
Configuration procedure
# Enable PoE for the PSE.
<PSE> system-view
Figure 22, configure PoE to meet the following requirements:
PSE
GE1/0/1 GE1/0/11
IP phone C
Command
system-view
poe update { full | refresh } filename [ pse pse-id ]
Command
display poe device [ slot slot-number ]
display poe interface [ interface-type interface-number ]
display poe interface
interface-number ]
display poe pse [ pse-id ]
display poe pse pse-id interface
display poe pse pse-id interface power
display poe-profile [ index index | name profile-name ]
display poe-profile
interface-number
AP A
AP B
230
power [ interface-type
interface interface-type