Configuring Network Parameters Assignment; Configuring Network Parameters In A Dhcpv6 Address Pool - HPE FlexNetwork 10500 Series Configuration Manual

Step
4. Specify an IPv6 subnet for
dynamic assignment.
5. (Optional.) Specify a
non-temporary IPv6 address
range.
6. (Optional.) Specify a
temporary IPv6 address
range.
7. (Optional.) Create a static
binding.

Configuring network parameters assignment

In addition to IPv6 prefixes and IPv6 addresses, you can configure up to eight DNS server addresses,
one domain name, eight SIP server addresses, and eight SIP server domain names in an address
pool.
You can configure network parameters on a DHCPv6 server by using one of the following methods:
•
Configure network parameters in a DHCPv6 address pool.
•
Configure network parameters in a DHCPv6 option group, and reference the option group in a
DHCPv6 address pool.
Network parameters configured in a DHCPv6 address pool take precedence over those configured
in a DHCPv6 option group.

Configuring network parameters in a DHCPv6 address pool

Step
1. Enter system view.
2. Create a DHCPv6 address
pool and enter its view.
Command
network { prefix/prefix-length |
prefix prefix-number
[ sub-prefix/sub-prefix-length ] }
[ preferred-lifetime
preferred-lifetime valid-lifetime
valid-lifetime ]
address range start-ipv6-address
end-ipv6-address
[ preferred-lifetime
preferred-lifetime valid-lifetime
valid-lifetime ]
temporary address range
start-ipv6-address
end-ipv6-address
[ preferred-lifetime
preferred-lifetime valid-lifetime
valid-lifetime ]
static-bind address
ipv6-address/addr-prefix-length |
duid duid [ iaid iaid ]
[ preferred-lifetime
preferred-lifetime valid-lifetime
valid-lifetime ]
Command
system-view
ipv6 dhcp pool pool-name
195
Remarks
By default, no IPv6 address
subnet is specified.
The IPv6 subnets cannot be the
same in different address pools.
If you specify an IPv6 prefix by
its ID, make sure the IPv6 prefix
is in effect. Otherwise, the
configuration does not take
effect.
By default, no non-temporary
IPv6 address range is specified,
and all unicast addresses on the
subnet are assignable.
By default, no temporary IPv6
address range is specified, and
the DHCPv6 server cannot
assign temporary IPv6
addresses.
By default, no static binding is
configured.
To add more static bindings,
repeat this step.
Remarks
N/A
By default, no DHCPv6
address pools exist.